This kit comes with the following:
- Micro Swiss Heat Tube 2.85mm/E3D Titanium Heat Break 1.75m
- E3D V6 Heater Block
- E3D Silicone Sock
- 40w High Precision Heater
- E3D Thermistor with wire harness
- Boca Bearing Set
- Thermal Paste
NOZZLE NOT INCLUDED. You will need to purchase the nozzle here separately as there are a lot of Choices you can make for your nozzle.
You will need to install these parts and then perform a heat tighten on the nozzle at at least 280c
If you don’t already have a high precision heater, you will also need the correct pins for install on your particular application.