3D printed camper water gauge housing

Just in time for summer fun, IT-Works’ Ben Brown wanted a weather tight enclosure for his camper’s water level gauge, so designed, 3D printed, and installed one.

Here’s his project:

A case to hold indicator gauge.

 

 

 

 

 

 

 

 

Tabs to pull out indicator for battery changes

 

 

 

 

 

 

 

 

Polycarbonate plastic window with UV filter

 

 

 

 

 

 

 

 

 

Indicator inside cover and case

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Plastic cover allows button to be pushed in a water tight container.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

A gasket to keep water out.

 

 

 

 

 

 

 

 

 

 

 

 

Drill 22 mm hole in camper ( allow slack on cord so indicator can be pulled out to change battery)

 

 

 

 

 

 

 

 

 

 

 

 

After 4 screws have attached case to camper (add some silicone behind seal) push in the indicator connected to probe wires.

 

 

 

 

 

 

 

 

 

 

 

 

 

Push on the cover and then tighten set screws with Phillips screwdriver to lock on cover.